Crystalyte Dual Motor Controller

 

This 20A controller allows two hub motors to be used at the same time.  The amp load will deliver 20A to each motor, which makes it total of a 40amp load.  It can handle between 36 to 72 volt.  It is ideal for use with quads and trikes.  The controller comes with an on/off switch, with the following connector:

- 4 pin connector for the throttle
- 5 pin connector for cruise control
- 3 pin connector for e-brake
- 6 pin connector for CycleAnalyst direct plug-in
- 2 pin connector for forward & reverse switch
- 5 pin mini-XLR for motor hall sensors
- 3 anderson connector for motor phase wires

 You can check out the video in YouTube: